Be earth friendly and create customized accessories for summer time gatherings!
You will need: Sewn pocket / sleeve measuring approximately 3.5” w x 10” h, cardstock, fabric ink or paint, ScanNCut, Brother vinyl in assorted colors, roll feeder, reusable plastic water bottle (1L size used in the photo), frisbee
Cut out the cardstock with the machine & discard the three center pieces of the stencil.
Lay the stencil over the top of the utensil holder and use it to guide where the fabric ink or paint is applied to the fabric. Press the stencil down firmly to ensure it doesn’t move around while the fabric is being covered.
Once all sections have been colored in, lift the stencil. Allow the holder to dry completely before using.
Done!
For Customized Water Bottle
Download WaterBottle_Design.fcm to your machine.
Load the roll feeder with the colored vinyl of your choice.
Cut out the design.
Carefully weed out all excess vinyl from the design.
Carefully lift off each design element and apply to the water bottle, smoothing out all bubbles.
Done!
For Customized Frisbee
Download Frisbess_Decal.fcm to your machine.
Select a vinyl color and load it into the roll feeder.
Cut out the design.
Repeat steps 2-3 with another color of your choice.
Weed out all excess vinyl from the designs.
Use the 2 colors to create a design on the frisbee. We chose to alternate the colors of the triangles surrounding the center of the design but get creative!
Apply all vinyl to the Frisbee and make sure all bubbles are smoothed out.
